Hub
The central connection point of every NAVIA installation — one unified, high-performance avionics network for Core, Displays, Sense, Emu and more.
Documentation →One network for the whole cockpit.
Navia Hub connects your Core to multiple Displays and every other Navia component, moving data at full gigabit speed while powering each device down the same cable.
Why it matters
Blazing 1 Gigabit Ethernet between all components — maps, traffic and video move without a bottleneck.
Up to 100 W at 48 V over a single Ethernet cable. No bulky power adapters, radically simpler installation.
Built for the aviation environment — uninterrupted connectivity and power for critical avionics.
Plug in any Navia device and it joins the network. No configuration ceremony.
The switch behind the second screen.
The Core Pro has one PoE port. The Hub turns it into four: plug it into the Core Pro and it passes power and gigabit data on to more displays and to an EMU. It needs no power feed of its own.
Technical specification
- Ports
- 5 × gigabit PoE, all alike
- Ports for your units
- 4, after the cable from the Core Pro
- PoE
- Passive 48 V
- Power budget
- 100 W in total, shared by everything behind the Core Pro
- Power supply
- From the Core Pro — no aircraft power connection
- Status lights
- Link and activity on every port
Navia is not TSO or ETSO approved. It is intended for VFR flight in gliders, motorgliders, ultralights, light-sport and experimental aircraft.
In the box
- Navia Hub
- Device registration card
- 4 M2 mounting screws
You will also need
- PoE cables — 0.4, 1, 3 or 5 m, or shielded Cat5e / Cat6 wired to T568B
Good to know before you install.
- 01The Hub mounts in the Navia rack or on a flat surface with two brackets, on the cabin side of the firewall. It needs no extra cooling.
- 02Never connect or disconnect a cable while the system is powered.
- 03The Hub has no internal fuse, and its ports carry 48 V on a pinout of their own. Never connect a laptop, a network switch, a FLARM display or an LX CAN cable to one.
- 04Add up what your PoE units draw: displays, EMU and Hubs share the 100 W of the Core Pro, however many Hubs are chained.
- 05Secure Ethernet cables with lacing cord or hook-and-loop ties. A tight cable tie crushes the wire pairs and costs speed and power.
This is an overview, not the installation manual. The manual for your unit governs the installation — follow it, or have an LX dealer do the work.
Questions pilots ask.
When do I need a Hub?
As soon as more than one unit needs PoE: a second display, or an EMU next to a display. A panel with a single display and no EMU needs none.
How many units fit on one Hub?
Four. The Hub has five ports and one of them takes the cable from the Core Pro. Sense and Traffic wire to the Core Pro itself, so they take no Hub port.
Does the Hub need its own power supply?
No. It is powered through the cable from the Core Pro.
Can I chain two Hubs?
Yes — connect any port of one to any port of the other. Everything behind them still shares the 100 W of the Core Pro.
Can I use ordinary network cables?
Use shielded Cat5e or Cat6 cable wired to the T568B standard. LX supplies tested cables in 0.4, 1, 3 and 5 m.
Put it in a system.
Tell the configurator what you fly and how much panel you have. It puts the Navia system together, with prices.